Baby Monitor Holder for Maxi-Cosi Tori Co-sleeper – 30° Holder for See Pro / See 2 Pro & Plus

Give your Maxi-Cosi baby monitor a fixed and stable position with this specially designed holder for the Maxi-Cosi Tori Co-sleeper.

Instead of placing the camera on a nightstand or a separate tripod, this holder attaches directly to the co-sleeper. This keeps the camera neatly in place and provides a good overview of the sleeping area.

The camera mount is set at a fixed 30-degree angle, directing the camera downwards into the co-sleeper.

The holder is 3D-printed and designed with extra attention to sturdiness, stability, and a neat fit.

Features & contents

• Specially designed for the Maxi-Cosi Tori Co-sleeper
• Fit tested and confirmed on the Tori
• Fixed 30° viewing angle
• Sturdy and stable construction
• Compact design that neatly matches the co-sleeper
• Suitable for compatible Maxi-Cosi See baby monitors
• No permanent modifications to the co-sleeper required
• Includes 2 large mounting screws
• Includes 4 smaller screws
• Baby monitor and co-sleeper are not included

Assembly

The holder is delivered partially unassembled. The two large screws must be attached by the customer. The four smaller screws for further assembly are also included.

After assembly, we recommend thoroughly checking all fastening points before using the holder. Also, regularly check the screws during use.

Compatibility

Maxi-Cosi Tori Co-sleeper:
✅ Compatibility tested and confirmed.

Maxi-Cosi Iora / Iora²:
⚠️ Compatibility not yet confirmed.

Although the construction of the Iora/Iora² may be similar, we have not yet been able to physically test this holder on these models. Therefore, we cannot currently guarantee that it will fit correctly.

Important

This holder is an independently designed accessory and is not an official Maxi-Cosi product.

Maxi-Cosi is a registered trademark of its respective owner. ROBB3D SHOP is not affiliated with, sponsored by, or officially endorsed by Maxi-Cosi.